Power Tools

Setup: 

1. Put on Safety Glasses and Ear Plugs

2. Mark material with a pencil and speed square for desired cut

3. Unlock saw by pushing down saw and pulling the locking pin

Sawing:

1. Plug in saw

2. Square material up against fence 

3. Hold material at least 6” away from the blade

4. Start saw by pulling trigger and slowly bring the saw down through the material 

5. Once saw has cut all the way through material, shut off saw and bring blade up 

Clean up:

1. Unplug Saw

2. Push saw down and push in the locking pin to lock the saw

3. Vacuum up all sawdust

Setup: 

1. Put on Safety Glasses 

2. Gather needed drill bits, battery, and drill

3. Clamp small board or parts 

4. Clean area of any oil or debris 

Drilling Small Holes:

1. Secure the shank the drill bit in chuck by holding the clutch 

2. Start drilling slowly

3. Once hole is started, drill as full speed 

4. Slow down drill speed when reaching the back of the material 

Drilling Large Holes:

1. Drill small Pilot Hole

2. Ensure that material is clamped well

3. Secure the shank the drill bit in chuck by holding the clutch on speed setting 1

4. Start drilling slowly

5. Once hole is started, drill as full speed 

6. Slow down drill speed when reaching the back of the material 

Clean up: 

1. Vacuum or sweep up all sawdust and debris 

2. Put battery onto the charger 

3. Hang Power Drill on Drill Hanger

4. Place clamps and drill bits back in their receptive drawers 

Setup: 

1. Gather needed driver bits, battery, and Impact Wrench 

2. Clamp small board or parts if need be 

3. Predrill screw hole if needed

4. Clean off area from an oil or debris

Driving Screws:

1. Secure driver bit into Chuck

2. Start screw slowly by pulling trigger half way 

3. Once screw is started, drive screw in until the screw head is flush by pulling trigger all the way

Driving Bolts:

1. Secure socket adapter in Chuck 

2. Start bolt BY HAND

3. Once the bolt is started, drive the bolt in until the hammer sound 

Clean up: 

1. Vacuum or sweep up all sawdust and debris 

2. Put battery onto the charger 

3. Hang Impact Driver on Drill Hanger

4. Place clamps and driver bits back in their receptive drawers